Polini dealer and service centre
Overhaul of Polini E-P3 / E-P3+ motors
Diagnostics, mechanical overhaul and testing of your Polini motor with original parts. A quote before any work.

The motor
Polini E-P3+: compact, light, Italian
Mid-drive motor designed and built by Polini Motori (Alzano Lombardo). We know it from the inside, because we open it.
- EVO2: new electronics, USB-C for diagnostics and Bluetooth for the handlebar controls
- Redesigned casings for better heat dissipation
- Compatible with belt drive and mechanical or electronic shifting
Polini E-P3 dealer and service centre. Our shop is on the list of service centres on the Polini website: check here.
Data from the Polini Motori website. Range: E-P3+ 80 Nm / 600 W, ST 80 Nm / 600 W, GP 90 Nm / 650 W, MX 105 Nm / 700 W peak.
Inside the motor
What we check part by part
Every overhaul goes through these components: we take them apart, measure them and replace only what is worn.
Our protocol
How we overhaul a Polini motor
Seven steps, all documented. No work starts without your approved quote.
- 01
Check-in and symptoms
We note the symptoms (noises, loss of power, errors) and test the bike before opening anything.
- 02
Electronic diagnostics
Error reading and status of sensors, controller and battery with the system’s diagnostic tools.
- 03
Motor removal
Motor removed and opened on the bench, with photos of every step.
- 04
Mechanical inspection
Check of reduction gears, freewheel, bearings and seals: measurements, not guesses.
- 05
Parts replacement
We only replace what is worn, with the right parts for your model.
- 06
Reassembly and calibration
Greasing, new seals, check of torque and speed sensors.
- 07
Testing and handover
Bench and road test, then we hand back the bike with a report of the work done.
Polini overhaul
Your Polini motor can be repaired
Sound familiar?
- Noises, squeaks or knocking from the motor
- Assistance that fades, surges or cuts out
- Error codes on the display or a motor that won’t start
- Play or creaking at the crank axle
What we do
- You send us model, year and symptoms on WhatsApp
- Diagnosis in the workshop
- A quote before we open the motor
- Gearbox, bearings or seals replaced with original Polini parts, then testing
Time: about 5 days when parts are available. Warranty: 1 year on the repair. Price: it depends on what we find, so you get a quote after the diagnosis and before we start.
FAQ
Frequently asked questions
Does a Polini motor need replacing, or can it be repaired?
In most cases it can be repaired: the Polini is designed to be opened and overhauled, and original parts are available after the warranty too.
Can I ship you the motor?
Yes, but only the motor, not the whole bike. Before shipping, message us on WhatsApp with model and symptoms: we tell you how to pack it and how we arrange the return.
How long does it take?
About 5 days if parts are available. If a part has to be ordered, we tell you with the quote.
Is the repair guaranteed?
Yes, 1 year on the repair.
How much does an overhaul cost?
It depends on what is worn: after the diagnosis you get a quote, and we only start if you accept it.
Are you a Polini service centre?
We are a Polini dealer and service centre: our shop is on the list of service centres on the Polini website.
Send us your Polini’s symptoms
Model, year and what is happening: we reply with the next steps and timing.



